I can remember reading about a supercharger installation I think on a 403 it had some good points but not enough it seemed to get any repeat orders, not sure if anyone has tried this in Australia, Geoff D . may be able to comment.
I suspect if you wanted to go down that route you would need to rebuild an engine with that in mind. To cross topic again Alfa big end bearings were often used on 2 litre engine rebuilds in the past as were MG and other pistons, despite the fact that a lot of the parts were sourced from four cylinder engines buying two sets of parts were often cheaper than buying Bristol specific parts.
Were they inferior I doubt it.
Geoff.
|