JoeF ,
You are probably best to try to locate a replacement oil separator and tube.
I have made the tubes in steel in the past but not a simple job . It required packing with dry sand,heating the tube to red hot at the area to be bent and slowly and carefully bend it without a kink .
If you can not locate one I can make one from chrome moly tube but the postage from Australia is a consideration .
The oil separator can be repaired and welded but would be time consuming and therefore expensive unless you have the facilities yourself
Can you please confirm the chassis number of PGD477, is it 405/4096 or 4049 ?
Geoff
Sydney/Australia
|