(Please type your reply above this line!!)
You may increase the space between the above lines as needed.
______________________
CURRENT MESSAGE FROM: pasini s
Hello,
here's where the expansion tank of my 409 is:
http://www.stefanopasini.it/Bristol_...nsion_Tank.htm
Of course I don't know if this applies to a 408 as well....
Cheers
Stefano
______________________
PREVIOUS MESSAGE FROM: classicgreendog
(Please type your reply above this line!!)
You may increase the space between the above lines as needed.
______________________
CURRENT MESSAGE FROM: Sam410
I'm not sure about the 408, but the 410's expansion tank is under the bonnet slam panel, between the grille and the radiator.. Easy to assume there isn't one!
______________________
PREVIOUS MESSAGE FROM: caspian pugh
---Quote (Originally by Rubbond)---
My ignorance no doubt but I've never heard of a core plug? .
---End Quote---
Even my Willie has heard of a core plug - you have a problem.
I have spoken to Butch our mechanic, he tells me that core plugs often rust but electrolytic corrosion between the edge and the block can cause them to loosen and pop with cooling system content pressurisation.
As Greg confirms, Mini core plugs in steel will fit most Chrysler V8 but the best replacements are brass core plugs from the States fitted with a little RTV sealant (non acetic acid cure) around the edge.
Hope this helps,
Cass.
______________________
This thread is located at:
http://www.bristolcars.info/forums/8...-purchase.html
To unsubscribe from this forum, please visit this page:
http://www.bristolcars.info/forums/s...bscription&f=3
You may reply to this email to post a reply to the forum.
You can also begin a new thread by sending an email to
(Please type your reply below this line!!)
______________________
This thread is located at:
http://www.bristolcars.info/forums/8...-purchase.html
To unsubscribe from this forum, please visit this page:
http://www.bristolcars.info/forums/s...bscription&f=3
You may reply to this email to post a reply to the forum.
You can also begin a new thread by sending an email to
(Please type your reply below this line!!)