Thread: 603 Dash veneer
View Single Post
  #7 (permalink)  
Old 30-11-14, 05:09 PM
Geoff Kingston Geoff Kingston is offline
Member
 
Join Date: Mar 2009
Location: West Wales.
Posts: 467
Default

I acquired a 603 where all the dash panels and instruments had been removed for refurbishment and all the lables on the wires saying what went where faded, salvation came in the form of another incomplete badly damaged 603 with all the dash and instruments still in place, this one had seen some weather as well so not all the screws holding things in place came out easily but any good mechanic should be able to do this for you for a lot less than you have been quoted. I stripped the spares car myself and refitted the dash and instruments to the other 603, in both cases this required removal of the steering wheel, this is achived by carefully easing off the centre cover removing the screws to its retainer and the large nut retaining the steering wheel. Then the covers over the indicator and cruise control switches have to be removed and the switches themselves slackened off as you need room to gently pull forward and lower the instrument panel to remove the instruments. Prior to pulling this forward you need to release the control end of the trip recorder cable from the small panel below and to the left of the steering. The only panel I found awkward because it was a very tight fit was that immediatly above the transmission tunnel, to fit this the tunnel cover and selector surround panel I already had fitted had to come off again but the lower dash does differ in design on the 603's so you may not have that problem.
One way I found to overcome the lable issue was remove switches one at a time and reconnect to the appropriate wires, the same approach can be used on the instruments though some warning lights have to be left suspended as they slot into the lense covers in the dash panels.
The eyeball air vents are retained by long screws covered by spacers which drop out easily which is another thing I found out the hard way and the under dash covers above the foot wells have to be off to help get at everything. Very important to make certain the speedo drive cable is fully home as well otherwise it is a fiddle to get at without pulling things apart.
Reply With Quote