![]() |
![]() |
|
8 & 10 cyl Bristol cars Type 407 onwards - restoration, repair, maintenance etc |
|
Thread Tools | Search this Thread | Display Modes |
|
|||
![]() On mine when I swapped from SU to Facet I checked the specs of the carb to make sure I knew what it wanted in terms of pressure and flow. The silver top pump seemed most appropriate for my small block but a red top is probably what you need.
I bought the kit which includes new bobbins etc and a selection of springs from Facet so you can alter the pressure of the pump by unscrewing the bottom of the pump and swapping the spring over. I had two goes at mounting it until I found a spot where it couldn't vibrate against anything. On mine it's very quiet (inaudible when running) and I'm happy with it. I didn't use a regulator and all seems fine. On previous cars (not Bristols ) I've used them and mounted them in all sorts of places - so I wouldn't worry too much about whether it's below the bottom of the tank or not - they seem to cope. Hope this is of some use! |