A few comments and questions
1/ Where did you get the copy of the removal and replacement instructions
2/ Following those instructions no matter where I placed the master cylinder I could not remove the fulcrum pin that attaches to the pedal there is not enough space to move the pin sideways
3/ The range rover cylinder I purchased has two mounting hole the same as is shown on the 410 diagram . They are above and below the cylinder , There are 2 studs on the firewall which slip into the holes and 2 nuts secure it all. I had to make a plate with these studs attached and mount it on the cabin side of the firewall. Isnt this the way the series 5 mounts?
|