|
|
|
|||||||
| 6 cyl Bristol cars Type 400 to 406 - restoration, repair, maintenance etc |
|
|
Thread Tools | Search this Thread | Display Modes |
05-03-22, 09:50 AM
|
|||
|
|||
403 Windscreen outer seal
I've just rebuilt my 403 windscreen. I'm now struggling to get the main outer seal installed. I've tried sliding it in before bolting the two frames together but after a few inches it gets too stiff. Is there some knack or tool to use to push it into the groove in the frame edge rather than sliding it round?
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Threaded Mode